How do I configure DGL-4300 WAN settings for ADSL modem?
Please note use only hard-wired network connections, to do the setting.
** Disable firewall in your PC to avoid login problem**
** Please power off and on both of your router and modem after you linkup both of the devices**
** Please unplug your cable modem power and plug it back before the first time setup**
Step 1 Connect Your PC (Laptop) to the Router (Port 1,2,3,4 either one of them) using Network cable.
Step 2 Launch your IE (Internet explorer) and key in 192.168.0.1 in the address column and press enter.
Step 3 Enter your Username: admin and no password (if it is default) click on Log in
Step 4 You will see a Dlink Game Router configuration Page , Click on Basic > WAN.
Step 5 Under Modes > WAN Mode > choose PPPoE, key in your ISP username and password, Reconnect Mode will be Always on and click on Save Settings
** Please note that if your internet plan is "unlimited" choose Always on, else choose Manual.
For Singnet user your Singnet username should end with
Example:
xxxxx@singnet
xxxxx@singnet1500
xxxxx@singnetbusiness
For Pacific net user your username should end with
Example:
xxxxx@pacnet1500
Username might be vary please check with your ISP for the correct username.
Step 6 Settings have been saved successfully, Click on Reboot the Device.
Step 7 Click on OK to reboot the Game Router.
Step 8 Click on Log in if you get the login page again. Username will be admin.
** Please key in the new login password if you changed the router login password, or else just leave the password blank.
Step 9 After login, click on Status > Device Info, and look under WAN section. If it connected to internet, you will get PPPoE connected and there will be a IP address under WAN.
Step 10 Once the router obtain a IP address, user is done with the internet setting.